THERMAL INSULATION OF THE FLOOR

For this purpose we use a Canadian system of thermal insulation with GAMO foam.
Thermally insulating new floor during its installation its underlay is covered with mudsills. Then a foam layer of the desired thickness is sprayed between them and flooring is laid on the top.
Advantages:
• there is no need of any insulation films;
• the foam prevents warm air from leaking through the insulated structure, increasing efficiency of

insulation to the maximum;
• the work is not time consuming;
• the foam hardens within 30 seconds, so it can be covered with finishing materials almost at once;
• even the hardest-to-reach places are insulated;
• very good sound insulation.

Thermally insulating already laid floor with an empty air cavity under it, the flooring is drilled every 40-60 cm making Ø10 mm holes, through which the empty air cavity is gradually filled with the foam. The holes are covered with wooden plugs.
It is a special compound of components that is used for this method, therefore thermal foam expands less and it takes more time to harden.

Advantages:
• there is no need of any insulation films;
• the foam prevents warm air from leaking through the insulated structure, increasing efficiency of insulation to the maximum;
• it allows to avoid expensive and time consuming disassembling of the structure;
• even the hardest-to-reach places are insulated;
• very good sound insulation.

We perform thermal insulation works throughout Lithuania and Latvia

www.icynene.lt
www.icynene.com